Setting SYSLOG Parameters
Use the following procedure to specify the SYSLOG server and the types of messages you want the CLI to log on the server.
1.Ensure that you are in Enable mode by entering the enable command in the CLI.
2.Use the following command to verify that the
ping <IP-addr>
3.Ensure that you are in Configure mode by entering the configure command in the CLI.
4.If you have not already done so, use the interface add ip command to set the IP address and netmask for the en0 Ethernet interface, as shown in the following example:
Note: The en0 interface is automatically created by the system and is reserved for the
5.Use the following commands to “add” the SYSLOG server to the
system set syslog server
Here is an example:
Enterasys | 55 |