Enterasys Xpedition 2000 Getting Started Guide 37
Installing the Hardware
Note: A hardware restriction prevents the Xpedition 2000 from supporting configurations
consisting of:
– Two (2) 1000Base-SX or 1000Base-LX Gigabit modules.
– Two (2) 100Base-FX modules.
However, the router does support a configuration consisting of one (1) Gigabit module and
one (1) 100Base-FX module.
1000BASE-SX and 1000BASE-LX Expansion Modules
The 1000BASE-SX expansion module supports multimode fiber (MMF), and the
1000BASE-LX expansion module supports single-mode fiber (SMF) as well as MMF. Figure21
shows how to plug your fiber cable into a port on the 1000BASE-SX or 1000BASE-LX expansion
module. The procedure following the figure describes how to set up and insert the cables.
Figure 21. Plugging an ethernet cable into a 1000BASE-SX or 1000BASE-LX expansion
module
The 1000BASE-SX and 1000BASE-LX expansion modules use SC-style Media Interface
Connectors (MICs) to attach to SMF and/or MMF cables.
To attach the segment cables to your 1000BASE-SX or 1000BASE-LX expansion module, obtain a
SMF and/or MMF cable with an SC MIC and plug the MIC into the port connector. When you plug
the other end of the cable into another device, insure that the cable connected to the transmit port on
the XP-2000 is connected to the receive port on the other device. The receive port on the XP-2000
should be connected to the transmit port on the other device.
Note: A hardware restriction prevents the Xpedition 2000 from supporting configurations
consisting of:
– Two (2) 1000Base-SX or 1000Base-LX Gigabit modules.
– Two (2) 100Base-FX modules.
However, the router does support a configuration consisting of one (1) Gigabit module and
one (1) 100Base-FX module.
21
87654321 87654321
1000BASE-SX
87654321
10/100BASE-TX
1
3
2
4
CONSOLE
10/100 MGMT
OK
ERR DIAG
HBT
RST
G2M-HTXA2-08 G2M-GSXA1-02
10/100BASE-TX 10/100BASE-TX
Tx
Rx
Link
AN
Tx
Rx
Link
AN
SYS