Enterasys Networks 2000 manual 100BASE-TX RJ-45 connector

5 6 7 8 10/100 MGMT

G2M-HTXA2-08

1 2 3 4

10/100BASE-TX

5 6 7 8

G20-B

The procedure following the figures describes

Installing the Hardware

Figure 19 shows the pin positions in the 10/100BASE-TX connectors.

87654321

Figure 19. 10/100BASE-TX RJ-45 connector

2.Make sure the TXD signal from the port emerges as an RXD signal on the switch, router, or host on the other end of the segment cable. Likewise, make sure the TXD signal from the port emerges as an RXD signal on the other end of the segment.

3.Plug one end of the cable into the port and the other end of the cable into the device at the other end of the connection.

100BASE-FX Expansion Module

The 100BASE-FX expansion module supports multimode fiber (MMF). FigureEnterasys20 shoNetworkswhere to plug your fiber cable into a port on the 100BASE-FX expansion module.

how to set up and insert the cables.

3

10/100BASE-TX 1 2 3 4

1

RST SYS

	G2M-HFXA4-08	3	Lnk	4	Lnk	7	Lnk	8	100BASE-FX
	Lnk
	Act		Act		Act		Act		4
	Lnk	1			Lnk	5	Lnk	6
	1	2	3			5	6	7	8 10/100BASE-TX
	CONSOLE								2
OK	HBT
ERR	DIAG

Figure 20. Plugging an ethernet cable into a 100BASE-FX expansion module port

The 100BASE-FX expansion module uses SC-style Media Interface Connectors (MICs) to attach to multimode fiber (MMF) cables.

To attach the segment cables to your 100BASE-FX expansion module, obtain an MMF cable with an SC MIC and plug the MIC into the port connector. When you plug the other end of the cable into another device, ensure that the cable connected to the transmit port on the XP is connected to the receive port on the other device. The receive port on the XP should be connected to the transmit port on the other device.

36 Enterasys Xpedition 2000 Getting Started Guide