Installation Overview

Installation Overview

The installation process is summarized in the following steps. The following sections in this chapter provide additional details.

1.Make sure the Access Points are mounted and configured as specified in Chapter 2.

2.Check the cable connectors to verify that they are the correct polarity for your installation.

3.Plan and implement a grounding system that meets local electrical codes and safety standards.

4.Install the RoamAbout Lightning Protector.

5.Provide and install an antenna support structure as necessary. Make sure that the support structure is connected to the grounding system.

6.Connect the exposed metal connectors of the low-loss antenna cable to the grounding system.

7.Mount the antenna to the support structure.

8.Connect the antenna cables.

9.Route and connect the low-loss antenna cable to the RoamAbout Lightning Protector.

10.Connect the cable assembly from the RoamAbout PC Card in the Access Point to the Lightning Protector.

11.Run the Access Point Manager Link Test program to aim the antenna and verify optimal placement.

12.After verifying that the communications link is fully operational, secure all cables and use weatherproofing tape to seal all outdoor connectors.

Verify Component Connector Polarity

Before you start the antenna installation, refer to Figure 3-1to verify that the polarity of each connector is correct for your installation. The components supplied with your outdoor antenna kit are configured with either Standard-N connectors or Reverse Polarity-N connectors, subject to the country where the kit was purchased.

3-2 Antenna Installation

Page 36
Image 36
Enterasys Networks 9033348-02 manual Installation Overview, Verify Component Connector Polarity