Determining the Antenna Locations

Other Requirements

The following describes other requirements to meet before installing the RoamAbout outdoor antennas.

Lightning Protection

A lightning rod must be placed close to the antenna mast or wall bracket. This is required to protect the antenna from direct lightning strikes.

Grounding System

Direct earth grounding of the antenna and the Lightning Protector is necessary to protect the installation from lightning and the build-up of static electricity. The wireless device and the Lightning Protector must be connected to the same ground. The antenna and the mounting structure require a separate earth ground connection. Check with a certified antenna installer to make sure the antenna is properly grounded.

Ensure that the cable between the antenna and Lightning Protector is at least 0.9 meters (3 feet) away from high-voltage or high-current cable.

Antenna Height

If you are mounting the antenna on a roof, it must be at least 1.5 meters (5 feet) above the roof line.

If you are mounting the directional antenna to a wall of a building, it must be high enough to achieve a clear line of sight. Mounting an omni-directional antenna to the side of a building can cause signal reflection and reduce distance.

NOTE

The installer is responsible for local building codes.

Access Point placement

The Access Point should be located indoors and connected to the outdoor antenna with a standard 6 meter (20 foot), 15 meter (50 foot), or 22 meter (75 foot) low-loss cable. A longer cable could cause additional signal loss and decrease the distance between antennas.

1-8 Site Preparation

Page 20
Image 20
Enterasys Networks 9033348-02 manual Other Requirements, Installer is responsible for local building codes