Enterasys Networks CM Version 1.0 manual Minimum Revision of X Modules for DC Power

Pre-Installation Tasks

Table 1-3 Minimum Revision of X Modules for DC Power

Model Name	Minimum 940 Part Number	Minimum 940 Revision
X-CM-00	4179	5A1
X-T32-00	4167	5A2
X-G32-00	4161	5A3
X-M2-00	4054	5H
X-M8-01	4162	5A
X-GT16-00	3977	5A
X16-FM	4059	5C
X8-FM	4055	5B
X4-FM	4050	5B
X-FAN	4085	5B
X-FAN-AC	N/A	N/A

1.Exception: If an X-CM-00 module meets the Minimum 940 Part Number revision and has a 2 digit 940 revision code of 4X (for example, 41, 42, and so on), the module is DC power- compliant.

2.Exception: If an X-T32-00 module meets the Minimum 940 Part Number revision and has a 2 digit 940 revision code of 4X (for example, 41, 42, and so on), the module is DC power- compliant.

3.Exception: If an X-G32-00 module meets the Minimum 940 Part Number revision and has a 2 digit 940 revision code of 4X (for example, 41, 42, and so on), the module is DC power- compliant.

Prepare Site Wiring for DC Power Installation

1.Ensure that a branch circuit disconnect device is installed, and that the device is switched to prevent power from being supplied to the DC power supply.

2.If desired, attach your wiring to the 2‐hole compression lugs provided.

For your convenience, Enterasys Networks ships with the DC power supply two 2‐hole compression lugs to which you can connect your wiring (6 AWG). These compression lugs are the correct size to fit over the positive and negative terminal studs. See Chapter 2, DC Power Supply Specifications for more details about the compression lugs.

1-8 DC Power Supply Installation