Enviro 50-1033 owner manual GAS Line Connection, To Test Valve Pressures

Initial Installation

QUALIFIED INSTALLERS ONLY

GAS LINE CONNECTION AND TESTING:

WARNING: Only persons licensed to work with gas piping may make the necessary gas connections to

this appliance.
	Manifold	Inlet
GAS LINE CONNECTION
		Pressure Tap
	Pressure Tap

• This stove is equipped with a certified flexible pipe

located on the right side of the unit terminating in a 3⁄8”

male NPT fitting. Consult your local authorities codes or

the CAN/CGA B 149 (1 or 2) installation code in Canada,

or in the USA gas installations follow either local codes

or the current edition of the National Fuel Gas Code ANSI

Z223.1.

• The efficiency rating of this appliance is a product

TP TH
TP
TH
T	P
	I
OL

OUT

H	O
	L
I

IN
OF
F
P
I
L
T	O
NO

thermal efficiency rating determined under continuous

operating conditions and was determined independently

of any installed system.

Pilot Adjustment	Hi/Low	Gas Control
Screw	Knob	Knob

Figure 50: Fully Labeled Gas Valve.

The appliance and its shutoff valves must be disconnected from the gas supply piping system during any pressure testing where the pressure exceeds 1⁄2 PSIG (3.45 KPa) or damage will occur to the valve.

The appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1⁄2 psig (3.45 KPa).

Always check for gas leaks with a soap and water solution after completing the required pressure test.

TO TEST VALVE PRESSURES

The pressure taps are located on the left side of the valve

•Turn set screw 1 turn counter clockwise to loosen,

•Place 5/16” (8 mm) I.D. hose over pressure tap system.

•Check pressures using a manometer.

•When finished, release pressure, remove hose & tighten set screw.

Table 7: Pressure and BTU Information.

	Natural Gas	Propane
Main Burner	#39 DMS	#53 DMS
Manifold Pressure	3.8” W.C. / 0.95KPa	11.0” W.C. / 2.7KPa
Min. Manifold Pressure	1.1” W.C. / 0.27KPa	2.7” W.C. / 0.67KPa
Max Supply Pressure	7.0” W.C. / 1.74KPa	13.0” W.C. / 3.28KPa
Min. Supply Pressure	5” W.C. / 1.24KPa	12.0” W.C. / 2.98KPa
Max BTU/hr Input	30,000 BTU/hr (8.80KW)	26,500 BTU/hr (7.76KW)
Min. BTU/hr Input	17,000 BTU/hr (4.98 KW)	14,000 BTU/hr (4.10KW)
Venturi Setting	1/16” min.	3/16” min.

NEVER USE AN OPEN FLAME FOR LEAK TESTING.

32