Installation
THERMOSTAT INSTALLATION:
1.Install the wall thermostat (12 or 24 Volt rated) in a location that is not to close too the unit but will effectively heat the desired area.
2.Connect the Thermostat or Timer using an 2 x 18 gauge wire from the unit to the thermostat.
If the unit has been placed in the HI / LOW mode, the unit will be taken to a low or idle setting when the thermostat is not calling for heat. When the thermostat calls for heat, the unit will go to the setting that is displayed on the control board Heat Indicator. If the heat in the room becomes to great, the high limit switch may turn the stove off and the switch will have to be manually reset. To reset the high limit switch, remove the right cabinet side. The switch is found behind the control panel. Avoid setting off the high limit switch.
Figure 23: Thermostat wire placement.
OPTIONAL SLIDER/DAMPER INSTALLATION: |
| |
NOTE: NOT APPLICABLE FOR GERMANY AND |
| |
NEW ZEALAND |
| Slider damper |
If you wish to adjust the slider damper externally (NOT | rod and knob | |
| ||
REQUIRED), please follow the instructions below. |
| |
|
| 7/16" Nut |
|
| 7/16" Clinching Nut |
|
| Slider damper plate |
| Figure 24: Slider/Damper Assembly. | |
| 1. To install the OPTIONAL slider damper rod, remove the left cabinet | |
| side and locate the slider damper plate. Install the 7/16” (11mm) | |
Slider/ | nut onto the slider damper rod, thread all the way to the end of | |
Damper | the threads on rod. |
|
Knob |
| |
| 2. Slide rod through the hole in the slider damper plate and install | |
| the 7/16” (11mm) clinching nut onto the rod and tighten completely | |
| onto the slider damper plate. |
|
| 3. | |
Figure 25: Slider/Damper Knob. | rod. Check slider damper for smooth operation. |
|
|
| |
20
