Secondary Installation
DOOR REMOVAL:
Figure 19: Top bolts for glass door.
Open the door by removing the two (2) 5/16’’ bolts located at the top outside corners of the glass frame (see Figure 19). Lift the bottom of the door up and remove from unit (see Figure 20).
CAUTION GLASS MAY
SEPARATE FROM DOOR.
Figure 20: Bottom hooks for glass
door.
INSTALLATION OF SURROUND PANEL:
The Sienna must have one of the panels installed around the unit; the unit panel, the filler panel, or the filler panel with trim. If you have trim for your filler panel, the trim must be installed before installing the filler panel onto the unit.
1. Attach one side trim to the top trim using a corner bracket (see Figure 21) to secure pieces together.
There are two (2) main pieces to each corner bracket. When installing the corner pieces into the trim the “B FACE” sides must face each other and the screw heads are to face out. With the bracket in place and the top and a side trim snug together use a flat head screwdriver to turn the two (2) screws in the bracket in to tighten it into the trim.
2.Slide the two (2) attached trim pieces onto the surround panel.
3.Attach the other side trim piece to the top trim using the same method used in Step 1.
4.Place the second side of the trim on the surround panel in the same manner use on the first side and secure in the same manner.
5.On the side trims there are holes 2” (50 mm) from either end. Using a Phillips screwdriver to place a #8 screw 11⁄4”
long in each hole and tighten (refer to Figure
22). This will keep the trim tight against the surround.
To install the panel, lift the panel upright in front of the fireplace with the four (4) hooks pointing towards the fireplace. Slide the hooks into their corresponding slots (see Figure 23). Ensure the hooks are pushed all the way into the slots and the notch on the hook must be on the bottom of the slot. The panels should be wiped with a damp cloth periodically.
Figure 21: Corner brackets
for trim.
19
