Secondary Installation
Figure 42: The left log rests on the left pin and ledge of the back log and the back of the andiron.
Figure 43: The last log, center log, rests on the end of the grate and on the ledge
Once the logs are in place the embers can be installed. Bags of ceramic fiber embers and rock wool are provided. The ceramic
Figure 42: Fourth Stage Log Set Installation. fiber comes in chunks that are about 2 inches (5cm) long. Place them irregularly around the burner. When there is a sparse but even layer of embers, spread the rock wool in the same manner. DO NOT pack the rock wool material as this could create an unsafe condition. The pieces should be lightly placed so they don’t completely block any of the tiny ports. DO NOT allow any of the embers to rest against the pilot assembly.
Caution: Use only the type of ember material supplied with this fireplace. Due to the irregular size of the ember material, there may be more than required. Use of other
Figure 43: Final Log Set Arrangement with Embers. foreign materials on the burners may create dangerous conditions.
Figure 44: Refer to this figure when adjusting the venturi and vent restrictor. Make adjustments so that the flame reaches the approximate height shown
NOTE: While the glass is still removed, it is recommended that the gas line be purged by lighting the pilot.
When lighting the fireplace for the first time since the log set and embers have been installed/replaced, watch for ignition at ALL the burner ports. If a long delay is noticed, turn the appliance off and wait for it to cool down. Then remove the glass
Figure 44: DV42DX Burning.and rearrange the ember material, making sure none of the burner ports are blocked.
31
