Enviro EF-II I How To Start Your Pellet Appliance, Turning Your Pellet Appliance Off

HOW TO START YOUR PELLET APPLIANCE

1.Fill hopper with pellets.

2.Switch the power on by pushing the rocker switch to the manual position.

3.Turn Dial A Fire knob to the 12 o’clock position. (The lower grade pellets may need a higher setting on the feed rate.)

4.Approximately 15 minutes after the fire was lit, the green light should come on.

WHEN THE GREEN LIGHT COMES ON, PUSH THE ROCKER SWITCH TO THE AUTO POSITION. Now the stove will shut off automatically if the fire goes out.

5.Wait until the fire is established, then turn the Dial A Fire knob clockwise to the desired heat output. (The stove may not be able to burn in the BLUE ZONE if poor quality wood pellets are being used. Adjust the slider damper to the appropriate setting.

6.Adjusting the blower speed control knob will vary the rate of airflow into the room by varying the speed of the convection blower. *NOTE: The convection blower may cycle to high automatically depending on the setting of the Dial A Fire knob and the blower speed control knob.

FAN

CONTROLLER

GREEN LIGHT

AUTO/MANUAL ROCKER SWITCH

HEAT OUTPUT

KNOB

DIAL-A-FIRE

TURNING YOUR PELLET APPLIANCE OFF

The auto/manual switch must be in the AUTO position during operation. To turn the stove off, simply turn the HEAT OUTPUT knob (knob “B”) counter-clockwise until the knob clicks to the “off” position. This will stop the feed of pellets. The blowers will continue to run and cool the stove.

SPECIAL NOTES

If the stove is left in the manual mode after the green light comes on, the auger will continue to feed pellets. Pellets may over flow the burn-pot after the fire goes out and also re-light.

The scale on knob “B” represents a range, not exact times. Wood pellets of differing quality may effect the performance/heat output of the stove. If the stove has trouble operating at the end of its range, adjust the heat output knob back slightly.

6