Initial Installation | |
REPLACING THE BLOWER: |
|
1. | Turn the unit off and remove the log set. |
2. | Remove the brick liner. |
3. | Remove the burner tray assembly by removing the |
| screw on either side of the tray, between the front and |
| rear burners. Lift the tray out. |
4. | Remove the four (4) 5/16” bolts that hold the blower |
| mounting plate to the back firewall. Use a light |
| lubricating oil on screws before removal. |
5. | Carefully pull the blower assembly into the firebox |
| (see Figure 8) disconnect the blower leads from the |
| harness and remove blower. |
6. To | |
| replace with new one and reverse steps 1 through 4. |
| Refer to “Secondary Installation - Installation of Panel |
| Set” and “Secondary Installation - Installation of Log |
| Set and Embers”. |
Figure 8: Blower (Fan) Removal. |
|
ADJUSTING THE VENTURIES:
•There is a separate venturies for each burner, see Figure 9.
•Remove one screw from the cover plate located below the ash shelf and loosen the other screw (do not remove) swing the cover plate out of the way and tighten screw down to hold it in place.
•With along screwdriver rotate spring clips to open or close the venturies to the desired setting.
The venturies allows the amount of air coming into the fireplace to be adjusted in order to accommodate different climates and venting arrangements. Start the pilot and then the burner. Make sure the pilot flame is burning normally and none of the burner ports are plugged. Let the fireplace burn for roughly fifteen9minutes and then examine the flames, compare the flames to Figure 16.
Rear log holder |
|
Front log holder | Ember tray & |
Rear burner | front burner |
| Door |
Venturies | Screwdrive |
| |
| Gold bar |
Air shutter cover plate | |
Figure 9: Venturi Adjustment.
The ideal flame will be blue at the base and light orange above. The flames should be of medium height. If the flames look like this, no venturi adjustment is needed. If the flames are fairly short and mostly blue, the fireplace is getting too much air. Therefore, the venturies should be closed slightly until the correct flames are achieved. Flames that are very orange, with tall, dark, stringy tips, are not getting enough air. Open the venturi until the flames clean up. If the venturi is opened, or closed all the way, and the correct flames cannot be attained, turn off the gas and contact the dealer.
Warning: Incorrect venturi adjustment may lead to improper combustion, which is a safety hazard. Contact the dealer if there is any concern about the venturi adjustment.
10
