Secondary Installation
INSTALLATION OF LOG SET AND EMBERS:
The placement of the logs is not arbitrary. If they are positioned incorrectly, the flames can be “pinched” and will not burn correctly. The burner come with five (5) locator pins, and the rear log has one (1) ledge, which make alignment easier. Using the pictures provided, carefully set the logs in place.
NOTE: The logs are fragile and should be handled gently.
CAUTION: Use only the type of ember material supplied with this appliance. Due to the irregular size of the ember material there may be more than required. The use of other foreign materials on the burners may create dangerous conditions.
If over time, through cleaning and servicing, these embers require replacement, contact the nearest ENVIRO dealer for replacement embers.
Figure 11: Step 1 of Log Placement.
1.The embers can be place before or after the logs are placed. A bag of ceramic fiber embers and rock wool embers is provided gently remove the ember material from the plastic bag. Spread a layer loosely in a random manner across the burner tray. Do not allow any embers to rest against pilot assembly. (See Figure 12 or 15 for proper ember placement.)
DO NOT pack this ember material as this could create an unsafe condition, leave embers loose
2.Carefully remove logs from box. Check to ensure there is no damage. It is very important to install all logs in their proper position to insure safe, optimum operating conditions.
3.Place the log set into the firebox. Locate each log by seating it down onto the burner tray support pins. Follow Figures 11 to 15 proper log placement.
Figure 12: Step 2 of Log Placement
Figure 13: Step 3 of Log Placement.
13
