FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.
A
THIS MACHINE IS HEAVY. USE TWO
OR MORE PEOPLE WHEN LIFTING.
CASTERS |
| |
1. | Turn stand (A) upside down, as shown in Fig 1F. | B |
2. | Align holes in caster assembly (B) with holes in |
|
| plates on stand. Place small 5/16” flatwasher on a |
|
| 5/16”x3/4” hex head screw. Insert screw through |
|
| hole in caster assembly and thread into hole in |
|
| stand. Repeat for all holes in all casters. |
|
3.Tighten hardware by hand, then set with a 12mm
wrench. | Fig. 1F |
C
LEGS TO MOTOR/BLOWER | A | ||
ASSEMBLY |
|
| |
1. | Place motor/blower assembly with the motor down. |
|
|
| (Fig. 2) |
|
|
2. | Place 3/8” (18 mm) flatwasher on knob (A) Fig. 2. |
|
|
3. | Align holes (B) on legs with holes (C) in the mo- | B | |
| tor/blower assembly. Legs should extend up. Insert | ||
|
|
| |
| knob through hole (B) in the legs and thread into |
|
|
| Fig. 2 | ||
| hole (C) in the motor/blower assembly. Tighten | ||
| knob securely. |
|
|
4. | Repeat steps for all knobs on both legs. |
|
|
|
| ||
D 
ATTACHING STAND TO LEGS ON |
| A |
|
| |
MOTOR/BLOWER ASSEMBLY |
| B |
NOTE: TWO PEOPLE ARE NEEDED FOR THIS STEP. | C | C |
| ||
|
|
Place all four stand posts (A) Fig. 3 into four legs (B) on motor/blower assembly.
Fig. 3
