Power

Freeze

A/V Mute

R/C ON

E-ZoomOFF

 

3

2

4

1

5

 

Enter

Esc

on/off switch

Solving Problems with the Remote Control

The projector doesn’t respond to remote control commands.

■Make sure the remote control is turned on.

■Make sure you are within 30 feet of the projector, and within range of the projector’s front or back sensor (approximately 30° to left or right and 15° above or below).

■The remote control batteries may not be installed correctly or may be low on power. To test the batteries, press the light button. The other buttons on the remote should light up temporarily. If they don’t, you need to change the batteries as described on page 30.

■Dim the room lights and turn off any fluorescents. Make sure the projector is not in direct sunlight. Strong lighting, especially fluorescent lights, may affect the projector’s infrared receivers.

■Turn off any nearby equipment that emits infrared energy, such as a radiant room heater.

You can’t control the mouse pointer with the remote control.

■Make sure the mouse cable is securely connected to both your computer’s mouse port or USB port and the projector’s mouse port. For details, see page 13 (for laptops) or Appendix A (for other systems).

■To use the USB mouse connection on a PC, your system must have a “clean” installation of Windows 98 (SR2), Windows Me, or Windows 2000. The connection may not work correctly if your system was upgraded from Windows 95.

USB support requires OS9 or higher on a Macintosh.

100Solving Problems