caution
Do not use the projector with the lens cap in place. The heat generated by the lamp can damage the cap.
Turning On Your Equipment
Make sure your projector and other equipment are set up and connected correctly, as described in Chapter 1 or Appendix A. Then turn on your projector, as described below, followed by any equipment you’ve connected to it. You can turn on your computer and video equipment in any order, but if you have both a computer and video source connected, you may have to switch to the desired source as described on page 21.
Turning On the Projector
Follow these steps to plug in and turn on the projector:
1. Remove the lens cap.
2. Connect one end of the power cord to the projector’s power inlet.
3.Connect the other end to an electrical outlet.
The power light on top of the projector turns orange, indicating that the projector is receiving power but not yet turned on. Wait until the light stops flashing, but stays lit orange.
20Using the Projector