Follow these steps to replace the lamp:

1.Turn off the projector, then unplug the power cord.

2.Allow the projector to cool down for at least an hour (if it has been on).

3.Turn the projector upside-down to access the lamp compartment.

4.Use a screwdriver to loosen the retaining screw on the lamp cover. (You can’t remove the screw from the cover.)

When the screw is loose, lift off the lamp cover.

)

5.Use a screwdriver to loosen the two screws holding the lamp in place. (You can’t remove these screws.)

6.Lift up the wire handle, as shown, and pull the lamp straight out.

warning

Let the lamp cool before replacing it. If the lamp breaks, handle the shards carefully to avoid injury.

handle

Maintaining and Transporting the Projector 87