Printing Problems
Only the Ppower light is on, but nothing prints.
■Make sure the interface cable is connected securely and that the cable meets the system requirements on page 57 and page 58.
■Run a printer check as described on page 47. If the check page prints, make sure your printer and application software are installed correctly.
■If you’re printing on a network, you need to set up your printer for network printing, as described in your electronic Reference Guide.
The printer sounds as though it is printing, but nothing prints.
Make sure the print head nozzles are not clogged. To clean the print head, see page 35.
Printing is too slow.
Make sure your system meets the requirements listed on page 57 and page 58. If you’re printing a
You may also need to:
■Clear space on your hard disk or run a defragmentation utility.
■Close open applications that you’re not using.
■Increase your system’s memory (RAM).
For the fastest printing, try the following:
■Choose Black ink if your document doesn’t include color.
■Set the Quality/Speed slider to
Speed.
■In the printer software’s Advanced dialog box, turn MicroWeave® off and turn High Speed on.
■If you’re using the parallel port, enable ECP/DMA mode on your computer’s parallel port for maximum print speeds. See your computer documentation or the manufacturer for instructions.
Your printer makes noise when you turn it on or after it has been sitting for a while.
Your printer is performing routine maintenance.
49