Replacingl i the Photoconductor
Unitit and Waste Toner Collectorll
Photoconductor Unit | S051061 |
photoconductor unit
front cover
The control panel display lets you know when to replace the photoconductor unit. Since the waste toner collector is part of this unit, it is replaced at the same time. Ocassionally, the waste toner collector may need to be replaced separately. See page 3 for instructions.
The photoconductor unit requires careful handling. Avoid exposing the unit to room light any longer than necessary. Also, don’t touch or scratch the surface of the drum.
1Turn off the printer and open the front cover.
2Turn the large lever
counterclockwise 90 degrees.
3Turn the small lever on the
photoconductor unit to the right.
4 Pull the photoconductor unit out about 12 inches (30 cm).
5Grab the handle at the top of
the photoconductor unit and gently pull it all the way out.
6Take a new photoconductor
unit out of its package. Hold the unit by the handle and remove the protective sheet as shown.
Don’t touch or scratch the surface of the drum. Avoid exposing it to room light any longer than necessary.
Continue ▲
2