Epson 8000 Replacing the waste toner collector separately

Replacingl i the Photoconductor Unitit and

Waste Toner Collectorll (Continued)i

Waste Toner Collector S050020

waste toner collector

front cover

7Position the unit over the guide rails inside the printer. Then carefully slide it all the way in.

8Turn the small lever on the unit to the left.

9Turn the large lever clockwise 90 degrees.

The display message appears for only one consumable part at a time. Check the control panel display for additional replacement messages.

Replacing the waste toner collector separately

The waste toner collector is replaced each time you replace the photoconductor unit. However, you may need to replace the collector separately, as shown.

1Grab the handle of the waste toner collector and press down on the tab above the handle to release the lock. Then pull out the collector and dispose of it.

2Take out a new waste toner

collector (S050020). Hold the handle of the collector and insert it all the way into the slot.

3 Close the front cover.

3