Epson 825 - page 20

Connecting to a Projector on a Network and Projecting 20

Screen Preview

Displays the multi-screen preview screen.

Click to display a preview with the settings you have

made. Click the displays to enlarge each Screen Preview to

full-screen.

Set options

Transmission performance during the transfer of computer

images can be adjusted. sp.40

Movie Sending Mode

Not enabled on this projector. The message "The connected

projector cannot play back movies." is displayed.

Disconnect

Disconnects the connection to the projector.

Signal intensity

This is displayed when the connection is made in Quick

Connection Mode. As the Signal intensity increases, so does

the number of lit indicators.

Switch toolbar display

The toolbar display is switched as follows. The toolbar display

remains as is until switched again.

Full

Normal

Simple

Contents

Main Contents Introduction Connecting with EMP NS Connection EMP NS Connection Useful Functions Connecting to a Projector on a Different Subnet Setting the EMP NS Connection Operation Using a Computer to Set Up, Monitor and Control Projectors Presentations Using Slideshow Appendix Page Page Making effective use of your projector Sending Images Via a Network (EMP NS Connection) Monitor, configure, and control the projector from a remote location Projecting directly from saved JPEG images on a USB device (Slideshow) Page Installing the Software Software Supplied Installing q A B C D E F q Page EMP NS Connection Summary Two Connection Modes and their Main Functions Advanced Connection Mode Quick Connection Mode (Only when the optional Wireless LAN unit is installed) Main functions EMP NS Connection Summary Steps for Connecting in Advanced Connection Mode Preparing to Connect Preparing the Computer For Windows For Macintosh Operating the Projector A B Operating the Computer A B C D q Using the Connection Screen Page Using the toolbar Page Page Page Page Page Example of Adjusting the Virtual Display Procedure before using the Multi-screen Display Function Setting the Virtual Display Enable the virtual display driver (Windows only) A B C Adjust the Virtual Display q A B C D q F A Page Page B C q Page Connecting to a Projector on a Different Subnet q A B q Making a Profile A B q Searching by Specifying a Profile Page C D Page A B General settings Tab Adjust performance Tab q Page Changing Settings Using a Web Browser (Web Control) q Displaying Web Control q Entering the IP address of the projector A B Projector Setup Page Using the Mail Notification Function to Report Problems q Management Using SNMP q Page Files that can be Projected Using Slideshow q jpg Specifications for Files that can be Projected Using Slideshow q Slideshow Examples Projecting images from a USB storage device Slideshow Basic Operations Starting and Closing Slideshow A B Closing Slideshow Slideshow Basic Operations A Slideshow Basic Operations q B Rotating the Image A B A B C Projecting Image Files D q A B C q Setting Image Display Conditions A B C Page Connection Limitations Supported Resolutions Display Color Connection Number Others Connection Limitations When Using Windows Vista Limitations when projecting from Windows Photo Gallery Limitations in Windows Aero Problems concerning monitoring and control Problems concerning network functions Cannot connect using EMP NS Connection Check the message on the screen and then apply the following countermeasures. The projector is not found when EMP NS Connection is started. Cannot connect in Advanced Connection Mode or Wired LAN connection When connecting with EMP NS Connection the image is not displayed or the image is slow to appear. Page Page Page Problems concerning monitoring and control Mail is not sent even if a problem occurs in the projector. Page System Requirements General Notes Copyright Notice Trademarks