Manuals / Epson / Computer Equipment / All in One Printer

Epson instruction manual D88 Bulk Feed Instructions, Itinery

Models: D88

1 18

Download 18 pages 63.48 Kb

Page 6

D88 Bulk Feed

D88 Bulk Feed

Instructions

1

2

6

4

3

5

ITINERY

1.Bottles and cartridge assembly (pre-filled and including 2 small

clamps for fitting to printer housing).

2.10ml Syringe

3.Small needle (only required for re-priming, see page 7)

4.Large extension

5.4 x air filters

6.Subli-Print CD (including colour correction profile and instructions)

4

Image 6

Epson instruction manual D88 Bulk Feed Instructions, Itinery

Contents

Subli-Print Tel 01332 855 Technical Support 01332 858 Fax 01332CONTENTS Installing & Setting up the Epson D88 printer After installationClick Advanced Setting up CorelDRAW 10 onwards Diagram DiagramPrinting with the Subli-Print ICC profile D88 Bulk Feed Instructions ITINERYThis allows the printhead to be manually moved Place the bottles to the left of the printer as shown NEVER PLACE THE BOTTLES HIGHER THAN THISRemove the backing tape from the black clamp on the tubes and fit it to the printer housing as shown After the ink charge print out a nozzle check to see if all the colours are printing correctly. If they are, you are set to go. If not perform a head clean and test the nozzle check again. You should see an improvement on the next nozzle check. If still not perfect you can perform one or two more head cleans do not overdo this exercise until you get a good nozzle check Re-filling the bottles Replace the large rubber bung firstRe-priming a system that air has been allowed to infiltrate Press the ink button on the printer and remove the cartridge setWorking with templates Select templateDiagram Tips on using templatesDiagram Working with templates continuedits tools Introducing CorelDRAWCorelDRAWs most common tools Common CorelDRAW tasksCommon CorelDRAW tasks continued Sublimation printables hints and tipsSelection handles Useful CorelDRAW tips General troubleshooting and tipsWhy is the image on mugs blurred after printing? Print quality on ceramics, plastic, metal etc appears weak?