17
Correcting Distortion in the Projected Image
There are two ways to correct distortion in projected images as below.
• Quick Corner
This allows you to manually correct each of the four corners of the
projected image separately. sp.17
• H/V-Keystone
This allows you to manually correct distortion in the horizontal and
vertical directions independently. H/V-Keystone correction is ideal for
fine-tuning Keystone distortion. You can perform easy corrections by
using the [ ], [ ], [ ], and [ ] buttons on the
projector's control panel. sQuick Start Guide
These two methods cannot be used together. When the " Keystone"
correction method is selected from the Configuration menu, the
correction method you choose is assigned to the control panel
[ ], [ ], [ ], and [ ] buttons. The default setting for
"Keystone" is set to " H/V-Keystone", when [ ], [ ], [ ],
and [ ] buttons are pressed, H/V-Keystone correction is carried
out.
Because "Quick Corner" and "H/V-Keystone Correction" can be
carried out while projecting a test pattern, you do not need to make
preparations by connecting a computer or other equipment.
Correcting Distortion with Quick Corner
APress the [Menu] button on the projector, and then
from the configuration menu select Settings -
Keystone. s"Using the Configuration Menu" p.40
BSelect "Quick Corner", and then press the [Enter]
button.
Press the [Enter] button again to display the selection screen from
which you can select one of four corners.
Procedure
Using the remote control Using the control panel