Correcting Distortion in the Projected Image 18
C
Use the [
h
] button on the remote control or the
[], [], [], and []
buttons on the
control panel to select the corner you want to adjust ,
and then press the
[Enter]
button.
DTo adjust the shape, use the [h] button on the
remote control or the [], [], [], and
[]
buttons on the control panel.
If the screen below is displayed during the correction, this means
that you have reached the correction amount limit.
ERepeat procedures 3 and 4 as needed to adjust any
remaining corners.
FWhen you are done, press the [Esc] button to exit
the correction menu.
Because the correction method was changed to "Quick Corner"
from "Keystone" in the Configuration menu, when [],
[], [], and []
buttons are pressed later, the
screen for selecting the corner in procedure 2 is displayed. Change
"Keystone" from the Configuration menu to "H/V-Keystone" if you
want to correct H/V-Keystone when pressing the [],
[], [], and []
buttons on the control panel.
qIf the [Esc] button is held down for about two seconds while
correcting with Quick Corner, the following screen is
displayed.
Reset Quick Corner: Resets the result of Quick Corner corrections.
Switch to H/V-Keystone: Switches the correction method to H/V-
Keystone. sp.44