Turning On Your Equipment
Make sure your document camera and other equipment are set up and connected correctly, as described in Chapter 1. Always turn on your projector or monitor first. Then turn on your document camera, as described below, followed by any other equipment you’ve connected to it.
You can turn on your computer and video equipment in any order. If you have both a computer and video source connected, you may have to switch to the desired source to see its image, as described on page 20.
Turning On the Document Camera
Follow these steps to plug in and turn on the document camera:
1.Connect one end of the power cord to the document camera’s power inlet.
AC IN | POWER | RGB OUT |
| VIDEO |
ON | RGB IN | OUT | ||
|
|
|
| USB |
|
|
|
| 0 |
|
|
|
| 1 |
OFF |
|
|
| A B C |
|
|
|
|
power inlet
2.Connect the other end to a grounded electrical outlet.
3.Turn on the projector or monitor.
4.Turn on the document camera.
AC IN | POWER | RGB OUT |
| VIDEO |
ON | RGB IN | OUT | ||
|
|
|
| USB |
|
|
|
| 0 |
|
|
|
| 1 |
OFF |
|
|
| A B C |
|
|
|
|
power switch
After a few moments, the upper lamps turn on.
5.Place your presentation material on the stage. You should see an image on screen.
18Using the Document Camera