NOTE: Read entire instruction sheet before you start installation and assembly.
WARNING•Do not begin to install your product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, call Peerless customer care at
•This product should only be installed by someone of good mechanical aptitude, has experience with basic building construction, and fully understands these instructions.
•Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard- ware and components.
•Never exceed the Maximum UL Load Capacity.
•Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
•This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.
•Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding power. See suggested torque values where applicable within these instructions.
Tools Needed for Assembly
•stud finder ("edge to edge" stud finder is recommended)
•phillips screwdriver
•drill
•1/4" bit for concrete surface
•5/32" bit for wood joist
Table of Contents |
|
2 of 10 | ISSUED: |
Visit the Peerless Web Site at www.peerlessmounts.com | For Technical Support Contact Peerless Mounts at |