Flush Mount Application
1 | Screw projector mount (A) into ceiling plate (G). Align the notch with one of the four holes of the ceiling |
plate (G) and secure projector mount (A) with a M5 x 10 mm socket pin screw (C) using security allen |
wrench (B) as shown in detail 1.
NOTE: Slotted set screw (K) is used to jam against the threads of mount to prevent any excess movement of the projector mount (A). Do not overtighten screw; overtightening screw will damage threads making
it difficult to separate the products.
WOOD
JOIST
CEILING
G
A
Attaching Adapter Plate to Projector
2 | NOTE: The projector you are installing may differ in |
appearance from the sample illustrated below. |
NOTE: Some projectors may have three or four attachment points. If projector has three attachment points, the unused leg may be removed.
Place projector upside down. Locate adapter plate (L) with notch* facing forward as close to projector center of gravity as possible without covering any mounting holes. Loosen channels, and if there are only three mounting holes remove fourth channel. Using one channel for each mounting hole, position feet of channels over mounting holes as shown. Important: If projector does not have at least three mounting holes, do not use this adapter plate. Once channels are in position retighten fasteners.
NOTE: Some projectors have feet which can be removed and the corresponding threaded insert can be used for a mounting hole.
*Notch indicates front of projector.
C K
NOTCH
A
G
DETAIL 1
CAUTION•It is the responsibility of the installer to ensure that the projector is properly ventilated. Feet of channels are used to raise the mount off the projector surface.
MOUNTING
HOLE
*
L
*FRONT OF PROJECTOR
7 of 10 | ISSUED: |
Visit the Peerless Web Site at www.peerlessmounts.com | For Technical Support Contact Peerless Mounts at |