Epson ELPMBPJF Attaching Adapter Plate to Projector Mount, or P, M,N, O

3	Attach adapter plate (L) to projector using one
	screw (M, N, O or P) for each channel as shown.

Tighten all screws, while keeping the center of gravity. Be sure that adapter plate (L) is straight. Adjust the feet of the channels to keep the adapter plate level. Tighten all screws with 4 mm security allen wrench (B) or wrench provided with projector mount, while keeping the center of gravity. If M3 screws are used, tighten using 2 mm security allen wrench (Q).

NOTE: Projectors may require different size screws for mounting. Use a combination of screws (M, N, O or P) and foot adjustment that will result in channels of adapter plate (L) fitting tightly against projector. Important: In order to properly engage the threads in the mounting holes, the screw must be turned at least 3 full turns.

NOTE: If using screw (M), place washer (R) between screw (M) and foot of channel.

LEG	M,N, O
	or P

FOOT OF

CHANNEL

Attaching Adapter Plate to Projector Mount

4	Attach projector, with adapter plate already on it,
	to the projector mount (A) by inserting the

projector mount (A) into the adapter plate connection and twisting until the adapter plate will no longer turn (about 75°). The spring loaded captive screw should line up with a corresponding hole on the adapter plate (this should line up automatically when the two are connected). Push down and tighten the spring loaded captive screw to secure the adapter plate to the mount. If not using the optional security feature, fasten thumb screw (D) in the hole opposite the spring loaded captive screw.

OPTIONAL: For security option, use #10-32 x 3/8" security screw (E) in the hole opposite the spring loaded captive screw. Tighten with security allen wrench (B). This will prevent the projector from being removed.

NOTE: Be sure to only use the #10-32 x 3/8" screw (E) (or the thumb screw (D) opposite the spring loaded captive screw.

WARNING