Problem Solving 78
fMail is not received even if an abnormality occurs in the projector (EMP-1825 only)
Is direct sunlight or strong light from fluorescent lamps
shining onto the remote receiver?
Set the projector up in a location where strong light does not shine onto the remote receiver. Or set the
remote receiver to "Off" from "Remote Receiver" in the configuration menu. s"Settings"-"Remote
receiver" p.45
Is the correct setting for the remote receiver selected? Check the "Remote Receiver" from the configuration menu. s"Settings"-"Remote receiver" p.45
Are the remote control ID and the projector ID matched? Press the [ID] button on the remote control pointing at the remote receiver of the projector to be operated.
When the remote control operation is disabled, turn off the projector and then turn it on again.sp.32
Are the batteries dead or have the batteries been inserted
correctly?
Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary. sp.82
Was a remote control button pressed for more than 30
seconds?
If any of the buttons on the remote control are pressed down for more than 30 seconds, the remote control
stops sending signals (remote control's sleep mode). This feature is to prevent the batteries running down if
the remote control buttons are held down accidentally such as when it is stored in a bag or if an object is
placed on top of it. When the button is released, normal remote control operation resumes.
Check Remedy
Is "Standby Mode" set to "Network On"? To use the mail notification function when the projector is in standby, set "Network On" in "Standby Mode"
from the configuration menu. s"Extended"-"Standby Mode" p.47
Did a fatal abnormality occur and the projector come to a
sudden stop?
When the projector comes to a sudden stop, mail cannot be sent.
If the abnormal state continues, contact your local dealer or the nearest address provided in the Support and
Service Guide. sEpson Projector Contact List
Is power being supplied to the projector? Check that your electrical outlet or power source is functioning correctly.
Is the LAN cable connected correctly? Check that the LAN cable is connected correctly. Reconnect it if it is not connected or it is not connected
correctly. sp.95
Is "Mail" set correctly in the configuration menu? Mail notification of abnormalities is sent according to the "Mail" settings in the configuration menu.
Check if it is set correctly. s"Network"-"Mail" p.62
Check Remedy