104 - When the Indicators Provide No Help

The image is cut up (Large)/Small
·The image is
disturbed.
·Noise appears
●Has the cable been connected correctly?
see page25, 32
●Is the selected resolution correct?
Align the computer with the signals supported by the projector. Refer
to the computer’s instruction manual for details on how to amend the
signals.
see page26
●Have the [Synchronization *, Tracking *, Display Position] settings
been correctly adjusted.
Press the [Auto] button to make the adjustments.
The [Menu] will be displayed to enable adjustment to be made.
see page47, 65
●Has the cable length been extended?
There are cases where noise will occur if the cable length is extended.
Either use the cable supplied or connect amplification equipment, etc,
and confirm the situation.
●Has the signal format setting for the image been set correctly?
Select the video signal format with [Menu] − [Image] − [Video Signal
Format]. There are cases where the video image signals being input
cannot be determined in the [Auto] mode.
see page67
●Do the input signals match the connected equipment?
Set the signal type with the [Menu] - [Image] - [Input Signal]
parameter. Set [RGB] for computer signals, and [YCbCr] or [YPbPr]
(depending on the equipment signals) for component video signals.
see page65
·The image is cut
up
·The image is small
●There is a possibility that the [Resize] setting has not been correctly
selected.
Press the [Resize] button.
see page52
●Has the [Display Position] been correctly adjusted?
Adjust with [Menu] − [Image] − [Position].
see page65
●Is the selected resolution correct?
Align the computer with the signals supported by the projector. Refer
to the computer’s instruction manual for details on how to amend the
signals.
see page26
●Amend the resolution for note-type and liquid crystal type
computers.
Either amend the resolution so that the display fills the entire screen,
or set the image signals so that only external output is possible.
see page25