You must also set the terminator switch to on or install an external terminator on one of the two SCSI connectors on your scanner if the scanner is the last device in the chain.

See your scanner documentation for more information on terminators.

If you have additional SCSI devices, make sure only the last device in the daisy chain is terminated. Use cables with

50-pin connectors at both ends, then fasten the connectors to the scanner and the next device with the clamps on the sides of the connector.

3.With a SCSI adapter, always turn on the scanner first; then start the computer.

Warning

Do not connect a parallel and a SCSI interface cable to the scanner at the same time. Always use shielded cables.

Checking Your SCSI Device Settings

The factory-set SCSI ID of the scanner is 2. The SCSI host adapter in the computer is normally preset to ID number 7. If you are going to add the scanner to a system in which one of your SCSI devices already has a SCSI ID of 2, change the ID number of the scanner to an unused number as described next:

1.Locate the SCSI ID switch next to the SCSI connectors on the rear panel of the scanner.

1-8 Installing the Interface Card