2.Select your preferred option:

Make changes to CONFIG.SYSWrite changes to file - CONFIG.ADD

If you select the first option, Setup copies your existing CONFIG.SYS file to CONFIG.BAK before it modifies the file.

If you select the second option, Setup copies the changes to a file called CONFIG.ADD. You can refer to this file later to modify your CONFIG.SYS file.

3.Select Continue. You see the Interface Options screen.

4.Select the bidirectional parallel option:

Bi-directional Parallel Adapter Support

5.Select Continue. You see the Parallel Interface Options screen.

6.Refer to the table below to select one of the options.

Epson Adapter J1-LPT1: - Address 03F8hEpson Adapter J1-LPT2: - Address 02F8h Most PS/2 Models - Address 038Ch

Select

If

 

 

 

 

J1-LPT1

The jumper on your bidirectional card is set to LPT1

 

 

and you want to use LPT1 as your scanner port

 

 

 

 

J1-LPT2

The jumper on your bi-directional card is set to LPT2

 

 

(factory default) and you want to use LPT2 as your

 

 

scanner port

 

 

 

 

PS/2

You are using the built-in bi-directional port on an

 

 

IBM PS/2

 

 

 

 

*default option

 

 

2-4 Installing Epson TWAIN