Epson M X - 8 5 Phillips Head #2 Screwdriver

Pull out

Fig. 5 Removing Manual Paper Feed Knob

3.Turn the Printer upside down, observing caution with the paper roll release

4.Loosen the four (4) Phillips head screws located in the extreme corners of the

bottom cover. NOTE:

Placing tape over the holes will prevent accidental loss of the screws when the Printer is inverted.

5.Turn the Printer right side up. Carefully lift the upper case from the left side. When the case is partially raised, reach in and pull control panel cable loose. Set the cover safely aside.

Phillips Head #2 Screwdriver

Fig. 6 Loosening All 4 Screws

- 6 -

Contents

Page Page Page Page LIST OF TABLES INTRODUCTION INSTALLATION 1. Unpacking & Set-upof MX-85 1.1.Unpacking 1.2.Repacking 1.3. Contents of carton 1.4. Operation site 1.5.Assembly 1.6. Opening the printer 1.7. Removal of shipping screws 1.8. Removal of the upper case Phillips Head #2 Screwdriver Lead Wire 2.Construction and Location of the MX-85Com- ponents Spacer 3. Setting of DIP Switches and Jumpers 3.1. Location of DIP switches and jumpers 3.2. Setting DIP switches - SW-Aand SW-B Pin No Off Factory-set OFF 4.Now using Table 2, select your transmission code: ASCII or Baudot 5.Set Line Spacing to desired position Table 3 Baud Rate Selection Table 4 ASCII Code Table Selection Pin No 3.3. Setting of jumpers Function Note Jumper 4. Power Supply 5. Cartridge Ribbon Installation 6. Paper Holder Installation Page 7. Gap Adjustment Paper Position of adjusting lever OPERATION Power On 1.LF/FF Functions 2. Self -Test 3. On-LineOperation 4. Theory of Operation 4.1. Low paper 4.2. Paper empty 4.3. 4K memory full 5. Paper Tear-Off MAINTENANCE AND PARTS REPLACEMENT Print Head replacement Fig. 22 Replacement of Print Head Appendix A ASCII Code Table Appendix B Baudot Code Table Appendix C Character Fonts