INSTALLATION

1. Unpacking & Set-up of MX-85

Before removing the MX-85 from the carton, check the box for evidence of shipping damage. If such evidence is present, notify the carrier immediately.

1.1.Unpacking

(1)Open carton.

(2)Remove accessories; ribbon, manual, etc.

(3)Grasp the MX-85 by, its underside and lift straight out with ‘packing material attached.

(4)Place the printer on a flat surface.

(5)Carefully remove packing material.

(6)Remove the vinyl cover.

1.2.Repacking

Perform in reverse order of above.

NOTE:

Be sure shipping screws and protective sheet for paper sensor are reinstalled. It is highly recommended that all original material be retained for use in reshipment of the MX-85.

- 2 -