47
When You Suspect a Problem
Image is out of focus (unclear)
• The image is
fuzzy
• Part of the image
is out of focus
• The whole image
is out of focus
• Have the “Sync.g,” “Trackingg” and “Position”
settings been adjusted correctly? If the configuration menu “Image” → “Auto Setup” setting has been set to “OFF,”
press the [Auto] button on the remote control to adjust these settings. If the
images have not been correctly adjusted after pressing the [Auto] button and
using the auto setup function, adjust the settings manually in their respective
menus. ([Menu] button → “Image” → “Picture Quality” → “Tracking,” “Image” →
“Picture Quality” → “Sync.,” “Setting” → “Screen” → “Position”) See “Image
menu” on page 36, "Setting menu" P.39.
• Are the image signal format settings correct? • When a computer or Component Videog device is connected, select the
appropriate setting for the input source you are using, in the “Image” → “Input
Signal” configuration menu.
• When a Composite Videog or S-Videog device is connected, select the
appropriate setting for the video system you are using in the “Setting” →
“Video Signal” configuration menu.
• Is the projector positioned at right angles to the
screen? See “Installation method” on page 12.
• Is the projector at the correct distance from the
screen? The optimum range for projection is 2.9-36.4 feet (87-1109 cm). Set the projector
within this range. See “Installation method” on page 12.
• Are the front feet set so that the image angle is
too big for the screen? If the image angle is too big the image will be out of focus vertically. See
“Adjusting the projection angle” on page 26.
• Is the lens dirty? See “Cleaning the lens” on page54.
• Has condensation formed on the lens? If the projector is suddenly taken from a cold environment to a warm
environment, condensation may form on the surface of the lens, and this may
cause the images to appear fuzzy. Set the projector up in the room in which it is
to be used approximately one hour before use. If condensation forms on the lens,
turn off the power and wait for the condensation to disappear.
• Has the focus been correctly adjusted? See “Adjusting the Display” on page 25.
• Is the lens cover still in place? See “Turning on the Projector” on page 22.