57
Projector Care
Replacing the lamp
1Turn off the projector and wait for the cool-down period to end.
(Approximately 20 seconds)
2Unplug the power cable and remove it, then wait for the lamp to
cool down. (Approximately 1 hour)
3Open the lamp cover.
Push in the tabs on the lamp cover and push it up to remove it.
4Loosen the screws holding the lamp in place.
5Remove the old lamp.
6Install the new lamp.
Press the lamp until it clicks into place, then tighten the two screws.
c• Wait until the lamp has cooled down sufficiently before opening the
lamp cover. It takes one hour after the projector’s cool-do wn period has
finished for the lamp to be cool enough.
• When the lamp is broken, replace it with a new lamp, or contact your
dealer for further advice. If replacing the lamp yourself, be careful to
avoid pieces of broken glass.