Epson R1400 Eco-Flo Shown

ECO-FLO CONTINUOUS INK SYSTEM PermaJet Assembly Instructions for:R1400

IMPORTANT

If your printer is new, set it up according to the enclosed manufacturers instructions.

This is a check to ensure your new printer and drivers are working correctly before the Eco-Flo System is installed.

It is very important you read these instructions carefully before you begin!

We will take you through the following steps:

1Preparing your Injector

2Setting up of the Inks in the bottle tray

3Installation of the modified injector to your printer

4Fitting of the Tube Supports System

5Producing your first print.

Only start work on the installation once you have read the

instructions fully!

What you will need to Install the Eco-Flo R1400

*Complete Eco-Flo R1400 Kit

*Sharp Blade (Stanley Knife type) & Scissors

*Measuring Tape or Ruler

*Marking Pen or Pencil

*Paper Towels

Please read carefully before you continue and refer to the components diagram over the page

*Injector Set with tubes attached

*Set 6 Inks & empty 100ml bottles

*6 Bottle Caps & clear piping tubes

*Tube Support Bracket with Self Adhesive Pads fitted

*Bottle Holder Tray

*Special Injector Lid & 2 Chip Blocks

*1x Grey/White Tube Clip with adhesive pad

*Installation Instructions and Profiles CD

*10ml Syringe & wing adaptor

*Pair of latex gloves

*6 Tube Clamps

*Foam Strip