Alcatel Carrier Internetworking Solutions Conference Phone Installing The Pod, Charging The Pod

Versatis_Conference_uk.qxd 31/03/2005 16:03 Page 29

29

2.2INSTALLING THE POD

2.2.1Inserting the battery pack

lOpen the battery compartment under the Pod.

lInsert the battery pack (7.2V 1800mAh), ensuring that the plug and connector are correctly aligned.

lReplace the battery cover.

2.2.2Connecting the Pod to the mains

lPlug the Pod power supply cable into the socket at the rear of the Pod.

lConnect the mains adapter to a 230V / 50Hz electrical socket.

Before using the Pod for the first time, we recommend that you leave it to charge up for 24 hours in order to optimise the performance and longevity of the battery pack.

2.3CHARGING THE POD

If the battery icon flashes or the LEDs on the Pod flash RED periodically during a call, the Pod needs recharging.

lTo recharge, plug the 230V mains adapter into the Pod. The battery is charged when the battery icon stops flashing.

lTo check that the Pod is registered on the base, press to take the line.

"If you hear the dial tone, the Pod is working.

lCheck that the symbol is full on (not flashing).

When the Pod battery is completely flat, it may take several minutes for the display to light up after you plug in the mains adapter.

2.4FOR MAXIMUM PERFORMANCE

Install your conference phone in a quiet location.

Keep the Pod within 50 metres of the base.

Do not move the Pod during calls.