Setting Up th e PriorityFax

Place the output tray in front of you and insert each of the two wire paper holders into the holes at the edge of the output tray, as shown below.

To attach the output tray to the output tray base, locate the holes on either side of the output tray base. Then insert the pegs on either side of the output tray into these holes, as shown below.

Rear

Front hole

Note

This tray can used in a horizontal position instead of the vertical position shown on the next page. If you plan to use the tray in the horizontal position, insert the pegs into the rear slots instead of the front holes. Then push the output tray as far back as it will go.

1-7