Ericsson LBI-39012A manual Monitor CLR Switch Operation In Scan, Channel Changes In Scan

Monitor (CLR) Switch Operation In Scan

The CLR switch does not operate while scanning inactive channels. When a channel becomes active, the CLR switch operates only during the scan hang time after the channel activity disappears.

Channel Changes In Scan

Pushing the channel switches (UP or DOWN) while scan is turned on will change the SELECTED channel assignment. If a signal is being received and the channel switches are pushed, the radio will revert to the new SELECTED channel assignment. After 2 seconds, if no activity appears on the new SELECTED channel, scanning will resume. if the SELECTED channel is changed to a channel not in the scan list, the new channel will be temporarily added to the scan list until the SELECTED channel is changed again.

∙Temporary channel deletions

The SCAN function must be turned off to make any permanent changes (additions, deletions, re-priorizations) to the scan list. While in scan, temporary channel deletions may be made to the scan list. The original scan list will be back in effect by either turning scan off (by pushing the SCAN switch ) or by turning the radio power off and back on.

When the radio stops scanning on an active channel, the channel may be temporarily deleted by pressing the applicable A1 or A2 key (pre-programmed for SCAN ADD/DELETE) or by going into Menu mode SCAN ADD/DELETE and pressing the CHANNEL/SELECT UP(+) button. The radio will immediately resume scanning while skipping over the temporarily deleted channel.

Temporary deletions cannot be made until the radio stops on an active channel. P1 and P2 channels cannot be temporarily deleted.

18