Control Channel Limits, Cleaning Instructions | Ericsson LBI-39110

Control Channel Limits

This option provides for limited scanning of a frequency set for a control channel. When programmed, the radio is only capable of scanning a subset of channels for a control channel. This is useful in large wide area scanning systems to speed up the scan process.

CLEANING INSTRUCTIONS

The radio can be cleaned with a damp cloth, using a mild solution of liquid detergent and water or with a soft cloth and furniture polish. Never use an abrasive or a petroleum based solvent cleaner.

BATTERIES AND RECHARGING

BATTERIES

Battery Voltage Indicator

A battery voltage is shown on the alphanumeric line of the display, when BATT keys

are pressed ( , ). “BATT-6,0” means that the battery has a charge of 6.0 Volts. A fully charged battery will have 6.5 Volts or more. A battery which is almost empty will have 5.6 Volts or less.

Low Battery Alarm

As a reminder that the attached battery needs recharging or replacing, an alarm signal sounds for a short time and the message “LOW BATT” appears in the display. Additionally, the red low battery LED indicator located on the top side of the radio will flash.

If the radio is left on, the low battery alarm will be repeated several times and, eventually, the radio will turn itself off.

27

Image 27

Ericsson LBI-39110 Control Channel Limits, Cleaning Instructions, Batteries and Recharging, Battery Voltage Indicator

Contents

Operators Manual Table of Contents Table of Contents Important Safety Information Explosive Atmospheres Safety InformationProduct has been exposed to rain or moisture or List of possible hazards follows Radio Frequency Energy Liquefied LP Gas Powered VehiclesOperating Procedures Dynamite Blasting CapsPage Introduction Page Momentarily Press User Interface ButtonKeypad Function Portion Recalls numbers from memory locations Numeric Portion Volume UP ButtonVolume Down Button Extended Features Locks the radio Enables/disablesFor placing/storing Duplex operation Serv Status IndicatorsFCN PWR Call Queued Not used Indicates the radio’s keypad is lockedAlert Tones Edacs Applications Call Originate Alert OUT of Range System Inoperative AutokeySystem Busy Call Denied Edacs Operation Volume AdjustOperation General Turning The Radio ON/OFF Group Selection-Direct Number Entry KeySystem Selection-Direct Number Entry Group Selection-Ramping Names Redial Key Locking The RadioProgrammable Flex Keys Interconnect Dialing Using Special Call Lists Individual Call NotificationStoring An Individual Call ID System Key usage Storing a Telephone Number To The Call ListRecalling calls from the call list Simplex Operation Call Timer CLR key Usage Last Digit Clear And Display ClearAlert Key Mute Unit. To enable the external mic, pressEXT MIC Handsfree Simplex Pause ScanScan ADD/DELETE SPC Call Time-outs Carrier Control Timer CCTOperator enters or . The length of pause is PC programmable Programmable Options Rx Disable-Group Option Automatic LoginSupervisory Mode TX Disable-Group Option Control Channel Limits Cleaning InstructionsBattery Voltage Indicator Low Battery Alarm Care and Maintenance Inserting and Removing a BatteryStandard Battery Removal Insertion Slide Indicator Optional High Capacity Battery Removal Plug the AC converter into an AC outlet Using Rapid Multi-ChargerCharging a Battery Out of the Phone Recharging Charging While the Battery is in the Phone Charging Your Battery Locate the end of the battery with round charging contacts Removing BatteryUsing the Rapid Travel Charger Using Smart Charging Accessories Restoring Battery CapacityAllow the radio to remain on until it turns itself off MAh Standard Battery Available OptionsOption Frequently Called Numbers Page Page Page Warranty Emergency Numbers