Removing Battery

1.Locate the end of the battery with round charging contacts.

2.Orient the battery with its inner surface down and place the round charging contacts on the pins in the horizontal compartment. Press the battery into place. The arrow LED pointing to the horizontal compartment should light up.

Follow these procedures to remove a Standard or a High-capacity battery from the horizontal compartment.

1.To remove a Standard battery, press the battery forward toward the pins and pull up.

To remove a High-capacity battery, squeeze and pull back on both of the battery’s side release buttons and lift up and away from the charger.

2.When you remove the battery from the charger, move the orange slide indicator on the battery to the plus position as a reminder that the battery is fully charged.

Using the Rapid Travel Charger

1.Connect the charger cable to the bottom of the radio unit. This will permit the charging

Page 32

Image 32

Ericsson LBI-39110 manual Locate the end of the battery with round charging contacts, Removing Battery

Contents

Operators Manual Table of Contents Table of Contents Important Safety Information Safety Information Product has been exposed to rain or moisture orList of possible hazards follows Explosive Atmospheres Liquefied LP Gas Powered Vehicles Operating ProceduresDynamite Blasting Caps Radio Frequency EnergyPage Introduction Page User Interface Button KeypadFunction Portion Momentarily Press Recalls numbers from memory locations Volume UP Button Volume Down ButtonExtended Features Numeric Portion Enables/disables For placing/storingDuplex operation Locks the radio Status Indicators FCNPWR Serv Not used Indicates the radio’s keypad is locked Alert TonesEdacs Applications Call Originate Alert Call Queued Autokey System BusyCall Denied OUT of Range System Inoperative Volume Adjust Operation GeneralTurning The Radio ON/OFF Edacs Operation Key System Selection-Direct Number EntryGroup Selection-Ramping Names Group Selection-Direct Number Entry Locking The Radio Programmable Flex KeysInterconnect Dialing Redial Key Storing An Individual Call ID Using Special Call ListsIndividual Call Notification Storing a Telephone Number To The Call List Recalling calls from the call listSimplex Operation System Key usage Alert Key Call TimerCLR key Usage Last Digit Clear And Display Clear Unit. To enable the external mic, press EXT MIC HandsfreeSimplex Mute Scan Scan ADD/DELETESPC Pause Carrier Control Timer CCT Operator enters or . The length of pause is PC programmableProgrammable Options Call Time-outs Automatic Login Supervisory ModeTX Disable-Group Option Rx Disable-Group Option Cleaning Instructions Battery Voltage IndicatorLow Battery Alarm Control Channel Limits Standard Battery Removal Insertion Care and MaintenanceInserting and Removing a Battery Optional High Capacity Battery Removal Slide Indicator Using Rapid Multi-Charger Charging a Battery Out of the PhoneRecharging Plug the AC converter into an AC outlet Charging Your Battery Charging While the Battery is in the Phone Using the Rapid Travel Charger Locate the end of the battery with round charging contactsRemoving Battery Allow the radio to remain on until it turns itself off Using Smart Charging AccessoriesRestoring Battery Capacity Option MAh Standard BatteryAvailable Options Frequently Called Numbers Page Page Page Warranty Emergency Numbers

Ericsson LBI-39110 Locate the end of the battery with round charging contacts, Removing Battery

Models: LBI-39110

1.Locate the end of the battery with round charging contacts.

Removing Battery

Using the Rapid Travel Charger