EXTERNAL CONTROL
IR REMOTE CONTROL
FireBall is preset from the factory to operate from the FB1 source button, however, the FireBall can be configured to use any one of the four source buttons using the on screen Setup menus. This is useful when there are multiple FireBalls installed at the same location, so all FireBalls don’t respond to the same IR commands. Use the following steps to change which source button (FB1, FB2, FB3, or FB4) each FireBall will listen for commands from:
Follow these steps to configure your FireBall to be controlled by any of the four IR code banks:
1.Press the Setup key on the remote to display the FireBall setup menu.
2.Select the External Control menu item.
3.Select the IR Remote Control menu item.
4.Select which source button to use to control this FireBall.
5.Press the new source button on your remote to reconfigure the remote and confirm the change by selecting the OK button on screen.
Repeat these steps for each FireBall in your system, selecting a different FB button for each.
FireBall™
PAGE 60
