ADDITIONAL INFORMATION

SPECIFICATIONS

Specifications are subject to change without notice. Please check the Escient web site for any changes to the specifications.

Video Specifications

NTSC

10 bit Video DACs

Frequency Response:

Composite: -2 dB @ 5MHz

S-Video: -2 dB @ 5MHz

SNR: 50 dB

Crosstalk: 50 dB

Input Impedance: 75Ohm

Output Impedance: 75Ohm

Audio Specifications

Frequency Response: 2 – 20,000 Hz, ±1 dB

THD+N (playback) < -80 dB FS A (< 0.01%)

A_D-DSP-D-A Dynamic Range: > 96 dB FS A @ 1kHz

Channel Separation: >95 dB

Full Scale Line Output: >2 Vrms, 50 k ohms

S/PDIF Output: 0.4Vpp to 0.6Vpp, <0.05Vdc (75ohm terminated)

Power Requirements: AC 90-132 VAC, 50-60 Hz

Power Consumption: < 60 watts

Physical Specifications

Width: ~ 17 3/8”

Height: ~ 4 5/8” w/ feet; ~ 4” w/o feet

Depth: ~ 11 7/8”; Installed 14 3/8”

PAGE 76

3rd Party Certifcations

FCC: US Part 15, Class B

NTSC Video Output: NTSC RS-170A

cETL Listing

Conforms to: UL STD 6500-2000

Certified to:

CAN/CSA STD E60065-00

CE

 

FCC Part 15, Subpart B

Class B

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio TV technician for help.

Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.

FireBall™ FP-1 User’s Manual

Page 76
Image 76
Escient FP-1 user manual Video Specifications, Ntsc