Using speaker cables with bare wire
Turn the terminal cap counterclockwise to loosen it. Insert the bare wire end properly into the terminal hole, and then tighten the terminal cap.
oDo not insert the insulation coating into the terminal hole. Insert only bare wire.
oMake sure it is fastened securely by pulling the cable lightly.
Using speaker cables with spades
Turn the terminal cap counterclockwise to loosen it. Fit the spade around the terminal, and then tighten the terminal cap.
oThe inside diameter of spades should be 8 mm (5/16") or more.
oMake sure it is fastened securely by pulling the cable lightly.
Using speaker cables with banana plugs
With the terminal cap tightened, insert the plug into the jack on the end of the cap.
oRead the instructions supplied with the banana plug.
For European customers
In accordance with European safety regulations, it is not possible to connect banana plugs into the speaker terminals on European models. The holes into which banana plugs are inserted have been covered with black caps. Connect the speakers using spades or bare wires. If the black caps become separated from the terminals, return them to their original position.
Connections When Using as a Pre Amplifier
After all connections are complete, connect the power cord plug to the AC wall socket.
oRead the instructions of each component you intend to use with this unit.
oBe sure to connect each plug securely. To prevent hum and noise, do not bundle the connection cords.
Right speaker | Left speaker |
| AUDIO IN |
|
Speaker | R L | Speaker |
terminals (R) |
| terminals (L) |
Power amplifier
RCA audio cable
Connect the PRE OUT terminals to the analog audio input terminals of the power amplifier using commercially available RCA audio cables.
Make sure to connect:
White plug e White jack (L: left channel)
Red plug e Red jack (R: right channel)
oAfter the connection, set the Pre out setting to “ON1” or “ON2” (page 16).
11
