3)This model also features an air purification filter which rests between the evaporative wicks and cleans the air as it provides humidity. Refer to the CARE AND MAINTENANCE section for instructions on installing and removing the air purification filter.
4)Remove a water bottle, observe the water
bottle cap (A), and locate the valve stem mechanism (B). The cap may be removed for filling and to provide easy access for cleaning with a long soft brush. The valve supplies a regulated amount of water to the water chan- nel and wick. Do not attempt to increase water flow by modifying this valve or adding additional holes to the bottle. Doing so will invalidate your warranty and may cause water damage to your home. NOTE: The water level can easily be observed through the tinted water bottle. It is time to refill the bottle when there is an inch or less of water remaining in the water bottle.
A
B
5)Take the water bottles to a sink, laundry basin, or bath tub. Use care in handling the water bottles. Do not drop the bottles. They will break. Turn bottle upside down and remove screw cap. Empty any remaining water in bottle, rinse the bottle thoroughly, and wipe outside clean with a cloth before adding fresh water.
6) To add water, place a soft cloth in sink and place the bottle on it. Turn on the cold water tap and
steady the bottle while filling. Each bottle holds 1.6 gallons. Do not over
fill. When full, replace the screw cap and tighten securely. Place the
bottle carefully on a protected flat surface and wipe it dry with a soft
cloth.
7) Return the bottle to its upright
position using the handle on the top
of the bottle. Slowly set the bottle in the recessed area, the top of the bot- tle flush with the top of the 2 in 1 air purifier & humidifier.
8) When positioned properly, the valve will open and water will flow
into the water channel. The water level will automatically remain at the
height of the pin in the water channel until water bottle is empty.
