Estate W10121806C To Convert Gas Pressure Regulator, To Convert Surface Burners

To Convert Gas Pressure Regulator

1.Turn manual shutoff valve to the “closed” position.

B

A

C

A. To range

B. Manual shutoff valve “closed“ position

C. Gas supply line

2.Remove grates.

3.Lift the cooktop by both front corners until the side support rods snap into position.

4.Locate the gas pressure regulator.

A

A. Gas pressure regulator

IMPORTANT: Do not remove the gas pressure regulator.

5.With a flat-blade screwdriver, remove the brass cap and flip the brass cap over so that “LP” is visible.

NAT

A

A. Brass cap

6.Reinstall the cap and tighten with the flat-blade screwdriver.

LP

A

A. Cap

To Convert Surface Burners

1.Remove grates from cooktop

2.Lift the cooktop by both front corners until the side support rods snap into position.

3.Remove the screws that hold each dual burner.

A

A. Dual burner screws

4.Lift each burner and slip it back to remove it.

5.Set them aside.

6.Locate LP gas orifice spuds for top burners in the bag containing literature included with the range. Four LP gas spuds are stamped “67.”

7.Remove Natural gas orifice spuds from the valve using a ³⁄₈" (0.95 cm) combination wrench.

8.Install LP gas orifice spuds in the valves.

B

A

A. Orifice spuds

B.Valves

9.Place the Natural gas orifice spuds in the parts bag for future use and keep with the bag containing literature.

10.Replace grates.

To Convert Oven Burner

1.Open the oven door and remove oven racks, oven tray, flame spreader and set aside.

2.Lift oven burner. The orifice spud is behind the oven burner air shutter.

A

A. Air shutter

11