1.Turn manual shutoff valve to the “closed” position.
B
A
C
A. To range
B. Manual shutoff valve “closed” position
C. Gas supply line
2.Remove grates.
3.Lift the cooktop by both front corners until the side support rods snap into position.
4.Locate the gas pressure regulator.
IMPORTANT: Do not remove the gas pressure regulator.
5.With a
LP
A
A. Brass cap
6.Reinstall the cap and tighten with the
NAT
A
A. Cap
To Convert Surface Burners
1.Remove grates from cooktop
2.Lift the cooktop by both front corners until the side support rods snap into position.
3.Remove the screws that hold each dual burner.
A
A. Dual burner screws
4.Lift each burner and slip it back to remove it.
5.Set them aside.
6.Locate Natural gas orifice spuds for top burners in the bag containing literature included with the range. Four Natural gas spuds are stamped “1.42.”
7.Remove the LP gas orifice spuds from the valve using a ³⁄₈" (0.95 cm) combination wrench.
8.Install Natural gas orifice spuds in the valves.
B
A
A. Orifice spuds
B.Valves
9.Place the LP gas orifice spuds in the parts bag for future use and keep with the bag containing literature.
10.Push back on the side support rods and slowly lower the cooktop until it snaps into position.
11.Replace grates.
To Convert Oven Burner
1.Open the oven door and remove oven racks, oven tray, flame spreader and set aside.
2.Lift oven burner. The orifice spud is behind the oven burner air shutter.
A
A. Air shutter
3.Locate Natural gas orifice spud stamped “48” in the bag containing literature supplied with the range.
4.Use a ³⁄₈" combination wrench and remove the Natural gas orifice spud.
A
A. LP oven orifice spud stamped with “48”
5.Install the number “48” Natural gas spud. IMPORTANT: Do not over tighten.
6.Place LP gas oven burner spud in plastic parts bag along with Natural gas cooktop burner spuds for future use and keep with the bag containing literature.
7.Reinstall oven burner.
8.Reinstall oven racks, oven tray and flame spreader.
13
