Estate W10121806C Pilot and Bypass Screws Conversion, Complete Conversion, Natural Gas Conversion

Models: W10121806C

1 28
Download 28 pages 45.93 Kb
Page 12
Image 12
Pilot and Bypass Screws Conversion

3.Locate LP gas orifice spud stamped “56” in the bag containing literature supplied with the range.

4.Use a ³⁄₈" combination wrench and remove the Natural gas orifice spud.

5.Install the number “56” LP gas spud.

AComplete Conversion

A. LP oven orifice spud stamped with “56”

IMPORTANT: Do not over tighten.

6.Place Natural gas oven burner spud in plastic parts bag along with Natural gas cooktop burner spuds for future use and keep with the bag containing literature.

7.Reinstall oven burner.

8.Reinstall oven racks, oven tray and flame spreader.

Pilot and Bypass Screws Conversion

1.Remove control knobs and set aside.

2.Remove upper grates.

3.Lift the cootop by both front corners unti the side support rods snap into position.

4.Open oven door.

5.Locate the two top fasteners and two bottom fasteners and remove them using a Phillips head screwdriver.

A Natural Gas Conversion

B

A. Top fasteners

B. Bottom fasteners

6.Set the front panel aside and locate the oven thermostat.

A

A. Oven thermostat

7.Locate the LP gas bypass screw in the bag containing literature included with the range. One LP gas bypass screw is stamped “48.”

8.Remove the Natural gas bypass screw with a flat-blade screwdriver, turning counterclockwise.

9.Install the LP gas bypass screw with a flat-blade screwdriver, turning clockwise.

A

B

A. Pilot screw

B. Bypass screw

10.Locate the LP gas pilot screw in the bag containing literature included with the range. One LP gas pilot screw is stamped “15.”

11.Remove Natural gas pilot screw with a flat-blade screwdriver, turning counterclockwise.

12.Install the LP gas pilot screw with a flat-blade screwdriver, turning clockwise.

13.Replace the front panel and screw bottom and top fasteners in place.

14.Replace the control knobs. Push back on the side support rods and slowly lower the cooktop until it snaps into position. Close the oven door.

Complete Conversion

1.Refer to the “Make Gas Connection” section for properly connecting the range to the gas supply.

2.Turn the manual shutoff valve in the gas supply line to the open position.

3.Refer to the “Check Operation” section for proper burner ingnition, operation and burner flame adjustments.

IMPORTANT: You may have to adjust the “LO” setting for each cooktop burner.

Checking for proper cooktop and oven burner flames is very important. The small inner cone should have a very distinct blue flame ¼" to ½" (0.64 cm to 1.3 cm) long. The outer cone is not as distinct as the inner cone. LP gas flames have a slightly yellow tip.

4.Close the broiler door and turn the knob to “OFF.”

5.Refer to the “Complete Installation” section to complete this procedure.

Natural Gas Conversion

To Convert Gas Pressure Regulator

Manual backgroundWARNING

Tip Over Hazard

A child or adult can tip the range and be killed.

Connect anti-tip bracket to rear range foot.

Reconnect the anti-tip bracket, if the range is moved.

Failure to follow these instructions can result in death or serious burns to children and adults.

12

Page 12
Image 12
Estate W10121806C installation instructions Pilot and Bypass Screws Conversion, Complete Conversion, Natural Gas Conversion