Flow Meter FC01-LQ
6 Parameter selection (menu option: PARAMETERS)
After configuration of the
During parameter setting, measuring operations are not possible (see Appendix 1).
The following parameters may be set in the Parameter selection menu:
6.1 Measuring time (menu option: MEAS. TIME)
The measuring time may be set between 1 and 30 sec., referring both to flow rate and medium temperature.
The effect of the measuring time may be compared to that of a filter; it is used to determine the average of the last measured values (measuring time 100 ms) after each measurement.
The set measuring time does not influence the measuring rate and display
6.2Limit switch 1 -
Limit switch 1 -
Depending on the configuration (see configuration menu) limit value 1 may be set either for flow rate or medium temperature.
The limit value may be set over the entire measuring range and is always related to the display value.
Limit switch
The hysteresis is determined by entering different
A specific definition of the operation
Example 1:
|
|
| ||||
|
|
|
|
|
| measured value |
|
|
|
|
|
| |
0 |
|
| ∞ |
| (flow/temperature) | |
|
|
|
| |||
ON |
|
|
|
|
| switching condition ON |
|
| hysteresis |
|
|
| |
OFF |
|
|
|
| switching condition OFF | |
|
|
|
|
fig. 23
Parameter selection | 41 |